FYP 2: WEEK 6

START TO WRITE UP INTRODUCTION AND LITERATURE REVIEW

From the workshop that i have attended last week, so i start to write chapter 1 and 2 which both is introduction and literature review.

In introduction is the background of project, problem statement, objectives and scope of project. In literature review there are some review from the related journal that i had study.

FYP 2: WEEK 5

ATTENDED 1ST FYP2 WORKSHOP

DATE: 22/3/2017

TIME: 3PM-5PM

VENUE: TTL G06

AGENDA: WORKSHOP ON INTRODUCTION AND LITERATURE REVIEW WRITING.

First workshop for this semester. from this workshop i get the guideline how to write introduction and literature review in the right way.

this workshop held in TTL G06 for up 2 hours lecture by the FYP committee/coordinator.

FYP 2: WEEK 4

Circuit Implementation With Microcontroller

This week is started to write the coding for microcontroller. Microcontroller used is an Arduino Uno based on the ATmega328 that has 14 digital input or output pins. Six of it can be used as the Pulse Width Modulator (PWM) outputs. It also has six analogue input pins, a USB connector, an ICSP header, reset button and 16MHz ceramic resonator. Arduino can be powered by AC-to-DC adapter, battery or connection to the computer. Voltage used for operating the Arduino Uno is 5V. However, 7 to 12V input voltage were recommended. Each input and output pins of DC current is 40mA and with a clock speed of 16MHz of flash memory of 32KB

FYP 2: WEEK 3

ATTENDED 1ST FYP2 BRIEFING

Date: 8/3/2017

Time: 3pm-5pm

Venue: TTL 06

Agenda: FYP new regulations and implementation for S1 2017

The first briefing for FYP2 students. The briefing is regarding the new regulation and implementation for FYP students.  The output from the briefing is:-

1) implemented plagiarism check. Every chapter cannot exceed than 30%

2) use QR code for attendance system

FYP 2: WEEK 2

CONSTRUCT THE CIRCUIT OF PROJECT

Start to construct the circuit used the component that bought form last week. Do the simulation first before proceed with the project implementation. 

after done construct the circuit then give 5V power supply to the project. the result is the red led not functioning. therefore, i have to troubleshoot the circuit.